The KE-Inject® System is produced
in the form of round (Ø), half-round (D) or
quarter-round (½D) ducts and is made of a coated, non
permeable textile material with groups of small holes
in the duct surface.
From a ventilation technology perspective, the KE
Inject System can be regarded as an active high
impulse system for mixing ventilation.
The KE-Inject System, unlike its low impulse
counterpart, can be used for cooling, ventilation
The reason for this is that KE Fibertec's high impulse systems,
unlike its low impulse systems, are less dependent on external
effects, such as convective heat currents in the room.
The supply air is delivered with high initial energy in the form
of velocity (momentum) through holes or nozzles, with the
effect that the air is discharged into the
room instead of being distributed through a textile
surface at low velocity.
KE Fibertec markets three types of KE-Inject Systems, with their
characteristic patented hole design running along the
duct's longitudinal surface. The systems are called
KE Inject Low Velocity, KE-Inject Medium Velocity and
Adjustments of the hole design enables KE Fibertec to control
the air flow very precisely. For short throw lengths and
a high degree of mixing, a KE-Inject Low Velocity System
with large spacing between the groups of holes is
If the air must travel a longer distance, the KE Inject JET System
with small spacing between the holes is applied.
Read more about
the KE-Inject System in our catalogue